DA Fat Grafting

delightful aestheticsDA Fat Grafting


Filling up the sunken areas for ratio balanced
and voluminous face that looks younger!

  • Duration Duration
  • Anesthesia method Anesthesia
  • Hospitalization Hospitalization
    Not required
  • Stitch removal Stitch removal
    After 7 days
  • Recovery Recovery
    3~4 days

DA Fat Grafting is recommended for those who

  • Forehead

    have sunken
    forehead and
    stuffy face

  • Cheeks

    Looks older due
    to sunken cheeks

  • Younger looking face

    want to
    look younger

  • Nasolabial Fold

    have deep
    nasolabial fold

transplantation of fat

DA Fat Grafting

Fat grafting involves collecting fat from areas where excessive
fats are accumulated, such as thighs, abdomen, etc.
These fat are then separate by centrifugal separator and only
the pure fats are used to graft at sunken areas such as
forehead and cheeks that requires improvement.

DA fat grafting process that separates only the pure fat with
centrifugal separator will bring highly satisfactory results with
high engraftment rate of the transplanted fat.

DA Fat Grafting VS PRP Fat Grafting

DA Fat Grafting PRP Fat Grafting
DA Fat Grafting PRP Fat Grafting
  • Increase skin elasticity
  • Natural & smooth skin
  • Lower side effect possibility
  • Superior skin regeneration
  • Effective in improving aged wrinkle
  • Lower side effect possibility
Smooth skin surface from delicate fat
grafting to each layers of fat after collecting
clean and high-quality fat through a
specific syringe for fat collecting process.
Using secondary centrifugation with
patient’s own blood to mix in the
platelet-rich plasma (PRP) with the fat
for tighter density and higher adhesion
Fat Grafting Areas

Fat Grafting Areas

  • Forehead, Temple
  • Sunken cheeks/ Cheekbone
  • Nasolabial fold
  • Eyelid, Under eye
  • Nose Bridge
  • Chin

DA Fat Grafting Key Points

  1. Natural & Voluminous

    Natural & Voluminous

  2. Skin Elasticity

    Skin Elasticity

  3. Delicate Procedure

    Delicate Procedure

  4. Use of centrifugal separator

    Use of centrifugal separator